THE SAFE SOLUTION TO POLISHING / DEBURRING THE INSIDE OF BORES
This innovative tool is designed for polishing/ deburring inside bores of metal or wooden components on a conventional manual centre lathe. It is the safe solution to polishing inside bores without resorting to potentially dangerous makeshift tools or hand held emery cloth.
The MST-IPA is portable and is mounted onto the lathe by simply clamping it into the lathes existing tool holder. All that is needed is a connection to a compressed air supply (min 6 bar). The pneumatic spindle runs at 20,000rpm and is switched ON/OFF simply by the control knob at the front of the tool block. The abrasive flap wheel is attached to the front of the pneumatic spindle.
A wide range of flap wheel grit grades (80 - 400 grit) are available for most applications.
Two models are available:-
MST-IPA (lite) - Spindle length 275mm / Abrasive flap wheel diameter 25-50mm/0.3HP
MST-IPA (Strong) - Spindle length 305mm / Abrasive flap wheel diameter 38- 100mm/0.6HP
MST-IPA (Lite) - Spindle length 275mm / Abrasive flap wheel diameter 25-50mm/0.3HP
MST-IPA (Strong) - Spindle length 305mm / Abrasive flap wheel diameter 38- 100mm/0.6HP
Enhance workplace safety while increasing productivity
